roco MultiMAUS User Manual

46

– If the display screen shows one of the
three main menus, you can call up the
required menu item by simply pressing
the function key with the corresponding
number.
– Press the “STOP” key to go back one
level.
For your safety and to protect against, e.g.
incorrect call-up or incorrect inputs: You
cannot confirm an input by pressing the
“STOP” key.
Always program on a programming track
which is fully disconnected from the rest of
the system (exception: you have switched
the multi MAUS to POM mode (page 49)).
SETTINGS
Backlight
Contrast
Language
Menu-Key-Time
Function Keys
Child Lock
Smart-Search
Cancel
Settings
Library
Speedsteps
Factory Reset
DISPLAY
USER INTERFACE
SPEED STEPS
STOP-MODE
Address
Automatic
Software
X-Bus
Calibration
Command Station

roco MultiMAUS Specifications

General

Control Protocol	DCC
Display	LCD
Speed Steps	14, 28, 128
Manufacturer	Roco
Category	Controller
Type	Handheld
Switching of turnouts and signals	Yes
Compatibility	DCC systems
Interface	XpressNet
Locomotive Control	9999 locomotive addresses