Rocstor ROCPRO T32 - Operating Information; Hardware Requirements and Precautions

ROCPRO™ T32 / User Manual
Operating Temperature : 32 ~ 104 F - (0 ~ 40 c)
Storage Temperature : -20~ 47 F - (-4 ~ 116 c)
Line Voltage : 100 ~ 240V AC
page 4 - 8
2. Operating Information
3. Hardware Requirements and Precautions
1. Both hard drives must be installed into the system for the device to work properly.
2. For the best performance of the system, it’s strongly recommended that you install hard
drives of the same model and if need be, replace faulty hard drives also with the same model.
If the same model of HDD is unobtainable, please replace with a model that is at least 20GB larger
in capacity.
3. All data on replacement hard drive will be erased once inserted into the system.
4.The actual usable storage capacity may dier from the stated capacity once the drives in the
systemhave been formatted.
5. Always safely dismount the volume from the Operating System before removing Rocpro T32.
from host computer.
6. Do not remove the hard drive(s) while the system is powered on or switch the position of
the drives. Always remember to power o the unit prior to removing the hard drives
(unless hot-swapping for the purpose of a rebuild in a RAID 1 conguration).
7. In RAID 1 mode, only 1 hard disk failure is permitted. Please seek help from data recovery
services should there be further data-loss due to failures in a RAID 0 mode.
8. It is highly recommended for users to back up important data. Rocstor will not be responsible
for any lost of data caused during the use of the unit or the recovery of the data lost.
9. Rocpro T32 requires a 12V/5V AC/DC Adapter. Please do not use other non-certied Power
Adapter using a third party power adapter may damage your storage unit causing data loss.
10. WARNING: Before you delete or switch your original RAID setting, please always backup yourdata
before changing your RAID settings. Your original data will be lost after you change your
RAID settings.