BEFORE USING THE K2
• Ensure that your K2 has been set to the correct voltage as used in your country.
• The back panel of the K2 power supply has a mains input socket, a signal
ground (earth) lift, a mic input socket, a voltage selector, and a mains power
socket which also incorporates a fuse.
• The front panel of the power supply has the mains power on/off switch, and a
blue LED (light-emitting diode) to indicate power status. It also houses the rotary
control for operation of the totally variable polar patterns. (See ‘NOTE’ below).
• The K2 can be used with mains supply voltages of between either 110-120V
50/60Hz, and 220-240V 50/60Hz with the correct switch settings.
• To select for 100-110V use, set the Voltage Selector to 115V.
• To select for 220-240V use, set the Voltage Selector to 230V.
• Note: On either voltage selection the mains fuse (inside the mains socket) must
always be a T500mA slow blow fuse.
NOTE: NEVER OPEN THE POWER SUPPLY, THERE ARE NO USER SERVICABLE
PARTS INSIDE AND LEATHAL VOLTAGES PRESENT!
FOR ALL SERVICE PLEASE SEND THE UNIT TO AN AUTHORSIED RODE
SERVICE AGENT OR CONTACT RODE AT WWW.SUPPORT@RODEMIC.COM
Having ensured that the power supply is now set to the correct voltage, you can
begin to connect the K2 to its supply.
5
NEVER REMOVE THE MAINS EARTH Doing so can have lethal consequences
ACHTUNG: LEBENSGEFAHR! ENTFERNE NIEMALS DEN SCHUTZLEITER
NON SCOLLEGATE IL FILO DI TERRA Potrebbe essere molto pericoloso per il
rischio di scosse elettriche
RELIEZ IMPERATIVEMENT L’ALIMENTATION A LA PRISE TERRE sous risque
mortel d’électrocution
NUNCA MANIPULE LA TOMA DE TIERRA, ESTA ACCION PUEDE TENER
GRAVES CONSECUENCIAS
To Next Page
Loading...
