22
Adjusting the Auxiliary Inputs
1. Press and hold the SET piston.
2. Turn the Select Knob counter clockwise (left) to “AUXILIARY”, and place the cursor on the
top line.
3. Release SET.
4. Rotate the Alpha Dial to select the desired control.
5. Turn the Select Knob clockwise (right) to place the cursor on the bottom line.
6. Rotate the Alpha Dial to obtain the desired effect. Note: An Audio Save may be performed to
save this setting as the default. Please refer to the “Audio Save”section.
DIGITAL REVERBERATION
The Rodgers 805C features an internal digital reverberation system. The volume, length and type of
reverberated sound can be individually changed. Any changes made to the reverberation settings from this
menu are temporary and are lost when the organ is turned off, unless they are saved by performing the
Audio Save procedure. Note: An Audio Save may be performed to save this setting as the default. Please
refer to the “Audio Save” section.
Setting the Reverb Volume
1. Press and hold the SET piston.
2. Turn the Select Knob counter clockwise (left) until the Console Display reads
“REVERB VOLUME”. Release SET.
3. Rotate the Alpha Dial to set the desired reverb level (OFF, -31.25 through 6.25 dB). Note: An
Audio Save may be performed to save this setting as the default. Please refer to the “Audio
Save” section.
Setting the Reverb Type
1. Press and hold the SET piston.
2. Turn the Select Knob counter clockwise (left) until the Console Display reads
“REVERB TYPE”. Release SET.
3. Rotate the Alpha Dial to set the desired reverb type (“ROOM 1”, “ROOM 2”, “ROOM 3”,
“HALL 1” or “HALL 2”). Note: An Audio Save may be performed to save this setting as the
default. Please refer to the “Audio Save” section.
Setting the Reverb Time
1. Press and hold the SET piston.
2. Turn the Select Knob counter clockwise (left) until the Console Display reads
“REVERB TIME”. Release SET.
3. Rotate the Alpha Dial to set the desired reverb time (“SHORT”, “NORMAL” or “LONG”).
Note: An Audio Save may be performed to save this setting as the default. Please refer to the
“Audio Save” section.
To Next Page