Rodgers 805C - Factory Default Settings and Restoration; Restoring Factory Default Combination Settings

41
Factory Default combination Settings
The Rodgers 805C is shipped from the factory with default settings on combination memories 1 and
2. Registrations on M1 and M2 can be changed, but if the original factory default settings are desired,
they can be restored by performing the following procedure:
 Restoring the Factory Default Combination Settings
1. Hold the memory piston to be restored (M1 or M2) for approximately five seconds. The
Console Display reads “LOCKED” or “UNLOCKED”.
2. While holding the memory piston, press and hold SET for an additional five seconds. The
Console Display reads “MEMORY 1 FACTORY DEFAULT” or “MEMORY 2 FACTORY
DEFAULT”.
3. Release both pistons. Note: Each memory must be individually restored by performing the
above procedure.