29
3. Rotate the Alpha Dial to set the channel number.
4. Press either the flashing MIDI coupler piston or General Cancel to exit.
The channel number for MIDI GT A coupler piston can be saved in the settings on a combination
piston or saved permanently by performing the MIDI Save procedure. Note: A MIDI Save may be
performed to save this setting as the default. Please refer to the “MIDI Save” section.
MIDI SAVE
Changes made to MIDI settings are temporary and will be lost when the organ is turned off unless
those settings are saved. This is done by performing the following procedure.
Saving MIDI Control Settings
1. While in any MIDI menu, make the desired changes.
2. To save, press and hold the SET piston, then press and hold General Cancel for approximately
five seconds.
2. Continue holding both pistons until the Console Display reads:
A L L M I D I
S E T T I N G S S A V E D
3. Release both pistons.
SUSTAIN SWITCH
A foot switch is located on the top left edge of the Great/Pedal expression shoe. This switch will
sustain MIDI sounds playing from MIDI GT A coupler piston. Press the switch to sustain, release to stop.
ADDITIONAL MIDI SETTINGS ON COMBINATION PISTONS
After additional MIDI settings have been selected on a MIDI coupler piston, these settings can be
saved on any General or corresponding Divisional combination piston.
Saving MIDI Settings on a Combination Piston:
1. Select the MIDI coupler piston (and organ stops, if desired).
2. Press and hold the SET piston.
3. Press the desired combination piston.
4. Release both pistons.
The factory default settings for the MIDI coupler pistons are:
To Next Page
Loading...
