Roger Technology B70/2ML - Page 30

EN
61
TEST
CLOSE
1 click
1 click
1 click
SEE CHAPTER 14 e 15
ACQUISITION
PROCEDURE
CHAP. 11.2
ACQUISITION
PROCEDURE
CHAP. 11.2
00
27
Yes
No
tada
No
Press and hold on
TEST
TEST
TEST
PROG
AP P-
Until...
10.2 Acquisition procedure:
PROG PROG
AP P-
AU to
AU to
x4 s 1 click
OPEN
CLOSE
MOTOR 1
OPENING
MOTOR 2
OPENING
Yes
1
1
2
MOTOR 1
CLOSING
1
2
MOTOR 2
CLOSING
2
PARAM. 25
DELAY TIME
PARAM. 26
DELAY TIME
x2 s
AU
AU
to
to
• 4VIWWERHLSPH463+JSVWIGSRHW%4 4MWWLS[RSRXLIHMWTPE]
• Press PROG again. Auto is shown on the display.
• MOTOR 1 starts opening at low speed.
• After the delay time set with parameter  (with a default time setting of 3 s), MOTOR 2 starts an opening manoeuvre.
3RGIXLIKEXISTIRQIGLERMGEPWXSTMWVIEGLIHXLIKEXIWXSTWFVMIƽ]8LIQIWWEKI$XWR ƽEWLIWSRXLIHMWTPE]JSV
2 s.
When the message $XWRWXSTWƽEWLMRKERHMWWXIEHMP]PMXSRXLIHMWTPE]13836GPSWIWƼVWXERHXLIREJXIVEHIPE]
set with parameter  (default setting 5 s), MOTOR 1 closes until the gate closed mechanical stop is reached.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
-JXLIJSPPS[MRKIVVSVQIWWEKIWEVIWLS[RSRXLIHMWTPE]VITIEXXLIEGUYMWMXMSRTVSGIHYVI
• %44)acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
• %440travel length error. Press TEST to clear the error, and check that both gate leaves are fully closed before
launching a new acquisition procedure.
For more information, see chapter 14 “Alarms and faults”.