EN
62
11 Index of parameters
PARAM.
FACTORY
DEFAULT
DESCRIPTION PAGE
$
SEE
CHAP. 10
Selecting automation system model 65
$
Automatic closure after pause time (from gate completely open)
65
$
%YXSQEXMGKEXIGPSWMRKEJXIVQEMRWTS[IVSYXEKIFPEGOSYX 65
$
Selecting step mode control function (PP) 65
$
4VIƽEWLMRK 65
$
Condominium function for partial open command (PED) 65
$
Enabling operator present function 65
$
+EXISTIRMRHMGEXSVTLSXSGIPPXIWXJYRGXMSRERHƈFEXXIV]WEZMRKƉ 66
MOTOR 1 Setting deceleration during opening and closing 66
MOTOR 2 Setting deceleration during opening and closing 66
Adjusting LEAF 1 position control 66
Adjusting LEAF 2 position control 66
Partial opening adjustment (%) 66
Type of signaling provided by COR output 66
Adjusting MOTOR 1 stop advance on gate open stop 66
Adjusting MOTOR 2 stop advance on gate open stop 66
Setting automatic closing time 67
Enabling of management for opening with automatic reclosure exclusion 67
Adjusting opening delay of MOTOR 2 67
Adjusting closing delay of MOTOR 1 67
Setting reverse time after activation of sensing edge or obstacle detection
(crush prevention)
67
Electric lock mode selection 67
Enable electric lock 67
Setting motor torque 67
Setting obstacle impact force sensitivity MOTOR 1 68
Setting obstacle impact force sensitivity MOTOR 2 68
Setting motor torque MOTOR 2 68
Setting start acceleration during opening and closing MOTOR 1 68
Setting start acceleration during opening and closing MOTOR 2 68
Enable lock release reverse impulse 68
Speed opening setting 68
Speed closing setting 68
Opening and closing approach distance setting MOTOR1 68
Opening and closing approach distance setting MOTOR2 68
To Next Page
Loading...
