Roger Technology BH30/606 - Electrical Connections

20
EN
20
11 Electrical connections
A switch or an omnipolar cut-off switch with a contact opening of at least 3 mm must be installed on the mains power line; put the
cut-off switch in OFF position and disconnect any buffer batteries before performing any cleaning or maintenance operations.
Ensure that an adequate residual current circuit breaker with a 0.03 A threshold and a suitable overcurrent cut-out are installed upstream
the electrical installation in accordance with best practices and in compliance with applicable legislation.
For power supply, use a H07RN-F 3G1.5 type electric cable and connect it to the terminals L (brown), N (blue), (yellow/green), located
inside the automation system.
Strip the insulation from the ends of the power cable wires which will be connected to the terminal (see ref. A), and secure the cable with the
cable retainer.
Measure the voltage on the primary mains power connection with a tester.
For the Brushless automation system to function correctly, the mains power voltage must be 230Vac (115 Vac) ±10%.
If the detected value does not comply with the above specied values or is not stable, the automation system may NOT operate eciently.
Connections to the electrical distribution network and to any other low-voltage conductors in the external section to the electrical panel
must be on an independent path and separate from the connections to the command and safety devices (SELV = Safety Extra Low
Voltage).
Make sure that the mains power conductors and the accessory wires (24 V) are separated.
The cables must be double insulated, strip them near the relevant connection terminals and lock them with clamps (not supplied).
The electrical connections and the gear motor BH30 testing operations are described in the installation manual of the control unit
B70/1DC.
+SC
8910 11 12 13 14 15 16 17 18
COM FT2 FT1 COS2 COS1 COM ST
+LAM
COM COM
ANT
COR
+24V
PED
PP
CH
AP
ORO
COM LNA LNB
ENC
POWER IN
MOTOR
YXZ
F2
F3
F1
PROG TEST
+
-
FC SB
M
LN
3x2,5 mm²
230 Vac
115 Vac
ALIMENTAZIONE
POWER SUPPLY
A
CAVO MOTORE
MOTOR CABLE