3. READER CONFIGURATION
Readers can operate in various operating modes which determine the method of communication
with controller. The mode and related output format can be configured with RogerVDM program
(Windows) or within the procedure of manual programming of operating mode
3.1 RogerVDM configuration
To perform this method reader has to be connected to PC via RUD-1 interface (fig. 3) and
programmed by means of RogerVDM software which is available at www.roger.pl.
Fig. 3 Connection of reader to RUD-1 interface
Fig. 4 Location of service contacts
Connection method
1. Connect the reader to RUD-1 interface (fig. 3) and connect the RUD-1 to computer’s USB port.
2. Place jumper on MEM contacts (fig. 4).
3. Restart the reader (switch power supply off and on or short RST contacts for a moment) and
orange LED SYSTEM will pulsate.
4. Start RogerVDM program, select
PRT v1/2.x
device, firmware version,
RS232
communication
channel and serial port with RUD-1 interface.
To Next Page
Loading...
