Software and Firmware Update
R&S
®
DDF205
57Getting Started 4073.0187.02 ─ 03
If update procedure fails.
If the update procedure fails, simply switch off the R&S DDF205 and restart
the update procedure.
Updating the DDF205 without front control panel
The
DDF205 without front control panel cannot be updated with this method.
In order to update the receiver firmware of a DDF205 without front control
panel, you will need the Update32 tool. The method of updating by using the
Update32 tool is described in chapter 4.3, "Receiver Firmware Update for
DDF205 without front control panel", on page 58.
Remote GUI on Notebook / desktop PC
If
you want to install the GUI for use on a notebook or desktop PC, you should
follow the procedure described in chapter 4.4, "GUI Installation for Remote
Access", on page 64.
If the R&S DDF205 cannot reboot
Due
to the fact that the R&S DDF205 also can be updated using the Update32
Tool (see "Updating the DDF205 with front control panel" on page 64), there
is a chance that the R&S DDF205 cannot reboot. Follow the steps described
in "If the R&S DDF205 cannot reboot" on page 64 to deal with this problem.
Receiver Firmware and GUI Update for DDF205 with front control panel
To Next Page
Loading...