Software and Firmware Update
R&S
®
DDF205
64Getting Started 4073.0187.02 ─ 03
Updating the DDF205 with front control panel
The DDF205 with front control panel can also be updated using the method
with
the Update32 tool. Please take note that this method cannot update the
GUI. This might cause version conflicts between receiver firmware and GUI.
For updating the DDF205 with front control panel, use the method described
in chapter 4.2, "Receiver Firmware and GUI Update for DDF205 with front
control panel", on page 50.
If the R&S DDF205 cannot reboot
Because the Update32 Tool performs its firmware updates over the LAN,
there
could be a conflict if another user is running the tool in the same network.
The R&S DDF205 might "hang" after a reboot because the bootloader gets
"trapped" by this Update32 on the network. In such cases the best advise is:
unplug the network cable during boot-up and find out who else is running
Update32 on the corporate network.
4.4 GUI Installation for Remote Access
This section explains how to install the Remote GUI for use on a notebook or desk-
top PC.
Internal installation
If you want to install the GUI on the R&S DDF205, follow the procedure
described in chapter 4.2, "Receiver Firmware and GUI Update for DDF205
with front control panel", on page 50.
4.4.1 Preparations
Required files and accessories
The
Remote Access GUI can be retrieved from either one of the locations mentioned
at "CD-ROM and Downloads" on page 50.
GUI Installation for Remote Access
To Next Page
Loading...