Software and Firmware Update
R&S
®
DDF205
62Getting Started 4073.0187.02 ─ 03
● Switch
ON the power to the R&S DDF205 ("target") to be updated. After a short
period a new entry will be shown in the list of targets as shown in figure below.
Fig. 4-1: List of targets for Ethernet Communication
●
Select the desired target and click the
"Start" button.
Updating process
The following dialog appears when the update starts. In the process, the flash is
being erased and then the new firmware is loaded into the flash.
Receiver Firmware Update for DDF205 without front control panel
To Next Page
Loading...