Preparation for Use
R&S
®
DDF205
9Getting Started 4073.0187.02 ─ 03
Installing the connector:
1.
Insert the Speakon® NL4FX connector into socket X1 on the rear panel.
2. Turn the connector clockwise until it is locked in place and secured by the safety
latch.
Removing the connector:
1. Press and chuck back the safety latch of the Speakon® NL4FX connector.
2. Turn the connector counterclockwise and withdraw it.
Fig. 1-1: Speakon® NL4FX
1.2.5.2 Connecting to the DC Source
The R&S DDF205 is connected to an external 10 VDC to 32 VDC source (e.g.
battery) via connector X1 on the rear panel. Recommended connector: Neutrik®
Speakon® NL4FX, see chapter 1.2.5.1, "Connecting to the Power Adapter",
on page 8.
DC supply voltage
Make sure that the available supply voltage is between 10 V and 32 V.
Observe
correct voltage polarity when connecting. Incorrect polarity may blow
the fuse on the DC converter inside the R&S DDF205 or damage the
R&S DDF205.
Setup
To Next Page
Loading...