Preparing for use
R&S
®
FPC
15Getting Started 1328.7409.02 ─ 05
● "Power" key is highlighted orange: R&S FPC is in standby mode (main AC
power switch is in position "I").
● "Power" key is highlighted green: R&S FPC is running and ready for oper-
ation.
Turning off the R&S
FPC
► Turn off the main AC power switch on the rear panel of the R&S FPC (position
"O").
The instrument is no longer supplied with AC power.
To disconnect from power
The product is in the standby state.
1. NOTICE! Risk of data loss. If you disconnect the product from power when it
is in the ready state, you can lose settings and data. Shut it down first.
Set the switch on the power supply to position [0].
The LED of the Power key is switched off.
2. Disconnect the product from the power source.
Turning the R&S FPC on and off
To Next Page
Loading...
