Remote Control
R&S
®
FPC
292User Manual 1178.4130.02 ─ 07
Suffix:
<n>
.
irrelevant
<k> Limit line
Return values:
<Status> • 0 for PASS
• 1 for FAIL
Example: //Perform a measurement and query the result of the check for
limit line 1.
CALC:LIM:UPP:THR -70
INIT;*WAI
CALC:LIM1:FAIL?
Usage: Query only
Manual operation: See "Upper Limit" on page 374
See "Lower Limit" on page 374
See "Upper Limit" on page 384
See "Lower Limit" on page 384
See "Upper Limit" on page 402
See "Lower Limit" on page 402
CALCulate<n>:LIMit<k>:LOWer:SELect <LimitLine>
This command selects the lower limit line.
You can either select a limit line that is already stored on the internal memory or create
a new one with CALCulate<n>:LIMit<k>:DEFine.
Suffix:
<n>
.
irrelevant
<k> Limit line
Setting parameters:
<LimitLine> String containing the file name of the lower limit line.
Example: //Select the lower limit line
FREQ:SPAN 0HZ
CALC:LIM:LOW:SEL 'GSM_Lower.rellim'
Usage: Setting only
Manual operation: See "Lower Limit" on page 374
See "Lower Limit" on page 384
See "Lower Limit" on page 402
CALCulate<n>:LIMit<k>:LOWer:THReshold <Level>
This command defines the level of a lower threshold limit line.
Suffix:
<n>
.
irrelevant
Remote Commands of the Spectrum Application
To Next Page
Loading...
Need help?
General
