Rohde & Schwarz FPC Series - Page 302

Remote Control
R&S
®
FPC
299User Manual 1178.4130.02 ─ 07
19.13.3 Amplitude
Commands to configure amplitude described elsewhere.
●
Reference level:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RLEVel
●
Level range:
DISPlay<n>[:WINDow]:TRACe<t>:Y:SPACing
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:ADJust
●
Reference position:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RPOSition
●
Reference offset:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RLEVel:OFFSet
●
Unit:
UNIT<n>:POWer
●
Preamplifier:
INPut:GAIN:STATe
●
Attenuation:
INPut:ATTenuation
INPut:ATTenuation:AUTO
INPut:ATTenuation:MODE
●
Impedance:
INPut:IMPedance
INPut:IMPedance:PAD
●
Transducer:
[SENSe:]CORRection:TRANsducer<td>:SELect
[SENSe:]CORRection:TRANsducer<td>:UNIT?
[SENSe:]CORRection:TRANsducer<td>[:STATe]
19.13.4 Bandwidth
Commands to configure the bandwidth described elsewhere.
●
Resolution bandwidth (3 dB):
[SENSe:]BANDwidth[:RESolution]
[SENSe:]BANDwidth[:RESolution]:CISPr..........................................................................299
[SENSe:]BANDwidth[:RESolution]:CISPr:AUTO................................................................300
[SENSe:]BANDwidth[:RESolution]:CISPr <Bandwidth>
This command selects the CISPR (6 dB) bandwidth for CISPR conform measure-
ments.
Parameters:
<Bandwidth> 200HZ | 9KHZ | 120KHZ | 1MHZ
Default unit: Hz
Remote Commands of the Receiver Application