Function Reference
R&S
®
FPC
390User Manual 1178.4130.02 ─ 07
Remote command:
Filter: [SENSe:]FILTer:DEMPhasis[:STATe] on page 310
Time constant: [SENSe:]FILTer:DEMPhasis:TCONstant on page 311
Reference Deviation
See "Defining the FM frequency deviation" on page 153.
Remote command:
[SENSe:]ADEMod:BANDwidth:RDEViation on page 310
20.6.5 Sweep Menu
Access: [Sweep]
Continuous Measurement...........................................................................................390
Single Measurement................................................................................................... 390
Continuous Measurement
See "Selecting the measurement mode" on page 156.
Remote command:
Measurement mode: INITiate:CONTinuous on page 262
Start measurement: INITiate[:IMMediate] on page 263
Single Measurement
See "Selecting the measurement mode" on page 156.
Remote command:
Sweep measurement: INITiate:CONTinuous on page 262
Start measurement: INITiate[:IMMediate] on page 263
20.6.6 Lines Menu
Access: [Lines]
Select Limits................................................................................................................390
Clear Limits................................................................................................................. 390
Audio Beep..................................................................................................................391
Select Limits
See "Selecting and evaluating limits" on page 156.
Remote command:
CALCulate<n>:ADEMod:LIMit:SELect on page 313
Clear Limits
See "Removing limits" on page 157.
Remote command:
CALCulate<n>:ADEMod:LIMit:DELete on page 312
Function Reference: Analog Demodulation
To Next Page
Loading...
Need help?
General
