R&S FSH Network Analyzer Mode
Evaluating the Results
Operating Manual 1173.6275.12 - 30 203
► The R&S FSH splits the screen. The upper screen shows trace 1, the bottom
screen shows trace 2. You can configure some aspects of the diagram
independently, like y-axis scale or displayed measurement format.
An [X] in front of the "Show Trace 2" menu item indicates that the dual trace mode
is active.
In addition, the menu of the "Result Display" softkey expands. It now shows the
available measurement formats that can be applied to trace 2.
For vector measurements, you can also display two traces in each diagram. This
way, you can view four results at the same time (S11, S12, S21, S22). For more
information on how to configure such a screen layout, see "Measuring the
Transmission".
Screen layout in dual trace mode
1 Result display trace 1
2 Result display trace 2
3 Measurement mode
4 Trace window 1
5 Trace information trace 1
- S-matrix
- calibration status
- measurement format
6 Trace window 2
7 Measurement format trace 2
8 Active trace indicator
To Next Page
Loading...
