R&S FSH Digital Modulation Analyzer
General Settings of the Digital Modulation Analyzer
Operating Manual 1173.6275.12 - 30 246
Ref Offset
Shows the current reference level offset.
For more information see "Setting a Reference Offset" on page 99.
Att(enuation)
Shows the current RF attenuation of the R&S FSH.
For more information see "Setting the RF Attenuation" on page 100.
Preamp(lification)
Shows the current state of the preamplifier.
For more information see "Using the Preamplifier" on page 101.
Sweep
Shows the current sweep mode.
You can select from
● Single: data is captured and results are displayed one at a time.
● Continuous: data is captured and results are displayed continuously.
For more information see "Selecting the Sweep Mode" on page 105.
"Sync Not Found" / "Sync OK"
Indicates whether synchronization was successful or not.
To successfully synchronize the R&S FSH to the signal, you have to enter the correct
values for center frequency, reference level or, in case of, for example, a WCDMA
signal, the correct scrambling code.
To indicate successful synchronization, the R&S FSH shows the label.
If the synchronization was not successful, the R&S FSH shows the
label.
Position
Shows the current GPS coordinates if you have connected a GPS receiver and have
activated the GPS receiver. If not, this field stays empty.
For more information see the Quick Start Guide.
To Next Page
Loading...
