R&S FSH Digital Modulation Analyzer
Measurements on 3GPP FDD Signals
Operating Manual 1173.6275.12 - 30 268
Active Channels
Shows the number of the currently measured channels.
9.4.3.3 Channel Table
The channel table is made up out of seven columns that show various information
about each channel. The number of rows depends on the number of channels that are
currently active. If a channel occupies more than one code, the results correspond to
all codes in the channel.
Channel Type
Type of code channel.
All code channels that the R&S FSH is able to recognize are shown with the correct
channel type and spreading factor.
Channels with the label CHAN are active code channels whose type could not be
detected. Codes that are inactive are not shown.
Chan#.SF
Code channel number including the spreading factor (in the form <Channel>.<SF>).
Symb. Rate (ksps)
Symbol rate that the code channel is transmitted with (7.5 ksps to 960 ksps).
T Offs (chips)
Shows the timing offset of the code channel in chips.
Pilot Bits
Shows the number of pilot bits the code channel contains.
Status
Status display of the code channel.
Power Abs (dBm)
Absolute power of the code channel in dBm.
Power Rel to CPICH (dB)
Relative power of the code channel in dB. The reference channel is the C-PICH or the
total signal, depending on the reference power you have selected.
To Next Page
Loading...
