Rohde & Schwarz FSW Series - Page 43

Instrument Tour
R&S
®
FSW
43Getting Started 1338.4102.02 ─ 08
ible (0 V / 5 V). You control the connector usage in the "Trigger" settings ([TRIG]
key).
The trigger output also controls signals by the frequency mask trigger available in
Real-Time mode.
The rear panel provides a third TRIGGER INPUT / OUTPUT connector, see
Chapter 5.2.12, "TRIGGER 3 INPUT/ OUTPUT", on page 54. (Not models
1312.8000Kxx)
For R&S FSW85 models, the second trigger (female BNC TRIGGER
INPUT / OUTPUT connector) on the front panel is not available due to the
second RF input connector (see Chapter 5.1.7, "RF INPUT 50 Ohm",
on page 43).
5.1.7 RF INPUT 50 Ohm
Provides RF input from a connected device under test (DUT) to the R&S FSW,
which is then analyzed in an RF measurement. Connect the DUT to the "RF
Input" connector on the R&S FSW. Do not overload the input. For maximum
allowed values, see the data sheet.
The specific connector type depends on the instrument model:
●
R&S FSW26: APC 3.5 mm male (compatible with R&S SMA)
●
R&S FSW43: 2.92 mm male (compatible with R&S SMA)
●
R&S FSW50/67: 1.85 mm male (compatible with 2.4 mm)
●
R&S FSW85:
– Input 1: 1.00 mm RF input connector for frequencies up to 85 GHz
(90 GHz with option R&S FSW-B90G)
– Input 2: 1.85 mm RF input connector for frequencies up to 67 GHz
For models 1312.8000Kxx:
1.00 mm RF input connector for frequencies up to 85 GHz (90 GHz with
option R&S FSW-B90G)
Front Panel View