Rohde & Schwarz FSWP Series - Measurement Selection; Measurements

Trying Out the Instrument
R&S
®
FSWP
55Getting Started 1177.5756.02 ─ 13
5.2 Measurements
Measuring the phase noise characteristics of a DUT requires a simple measure-
ment setup consisting of the R&S FSWP and a DUT.
Some measurements require additional equipment.
●
For additive noise measurements, the R&S FSWP must be equipped with the
optional Signal Source hardware.
●
For pulsed noise measurements, the R&S FSWP must be equipped with the
optional Pulsed Phase Noise Measurement application.
●
For pulsed additive noise measurements, the R&S FSWP must be equipped
with the optional Pulsed Phase Noise Measurement application and the
optional Signal Source hardware.
● Measurement Selection.................................................................................. 55
● The Phase Noise Measurement......................................................................56
● The Additive Noise Measurement................................................................... 58
● The Baseband Noise Measurement................................................................59
● The Pulsed Phase Noise Measurement..........................................................60
● The Pulsed Additive Noise Measurement....................................................... 61
● Adding Another Measurement Channel.......................................................... 62
5.2.1 Measurement Selection
Selecting a measurement
► Select the [MEAS] key.
The R&S FSWP opens a dialog box to select the measurement.
Measurements