Rohde & Schwarz R&S FPL1000 - Page 2

This manual applies to the following R&S
®
FPL1000 models with firmware version
1.80 and later:
●
R&S
®
FPL1003 (1304.0004K03) - FPL1000 with maximum frequency 3 GHz
●
R&S
®
FPL1007 (1304.0004K07) - FPL1000 with maximum frequency 7.5 GHz
●
R&S
®
FPL1014 (1304.0004K14) - FPL1000 with maximum frequency 14 GHz
●
R&S
®
FPL1026 (1304.0004K26) - FPL1000 with maximum frequency
26.5 GHz
In addition to the base unit, the following options are described:
●
R&S FPL1-B4, OCXO (1323.1902.02)
●
R&S FPL1-B5, Additional Interfaces (1323.1883.02)
●
R&S FPL1-B9, Internal Generator (1323.1925Kxx)
●
R&S FPL1-B10, GPIB interface (1323.1890.02)
●
R&S FPL1-B22, preamplifier (1323.1719.02)
●
R&S FPL1-B25, electronic attenuator (1323.1990.02)
●
R&S FPL1-B30, DC power supply (1323.1877.02)
●
R&S FPL1-B31, Li-Ion battery pack and charger (1323.1725.02)
●
R&S FPL1-K9, Power Sensor Support (1323.1754.02)
© 2021 Rohde & Schwarz GmbH & Co. KG
Mühldorfstr. 15, 81671 München, Germany
Phone: +49 89 41 29 - 0
Email: info@rohde-schwarz.com
Internet: www.rohde-schwarz.com
Subject to change – data without tolerance limits is not binding.
R&S
®
is a registered trademark of Rohde & Schwarz GmbH & Co. KG.
Trade names are trademarks of the owners.
1179.4657.02 | Version 10 | R&S
®
FPL1000
Throughout this manual, products from Rohde & Schwarz are indicated without the
®
symbol , e.g.
R&S
®
FPL1000 is indicated as R&S FPL1000, R&S
®
FPL1-Bxx/-Kxx is indicated as R&S FPL1-Bxx/-Kxx.