Preparing for Use
R&S
®
FPL1000
25Getting Started 1179.4657.02 ─ 10
The instrument operates on battery, DC, or AC power, whichever is supplied.
The R&S FPL1000 boots.
After booting, the instrument is ready for operation.
To shut down the product
The product is in the ready state.
► Press the [Power] key.
The operating system shuts down. The LED changes to orange.
To disconnect from power
The R&S FPL1000 is in the standby state.
1. NOTICE! Risk of data loss. If you disconnect the product from power when it
is in the ready state, you can lose settings and data. Shut it down first.
Set the switch on the power supply to position [0].
See Chapter 5.2.1, "AC Power Supply Connection and Main Power Switch",
on page 44.
The LED of the standby key is switched off.
2. Disconnect the R&S FPL1000 from the power source.
4.7 Connecting to LAN
You can connect the instrument to a LAN for remote operation via a PC.
For details on the connector, see Chapter 5.2.12, "LAN", on page 49.
Provided the network administrator has assigned you the appropriate rights and
adapted the Windows firewall configuration, you can use the interface, for exam-
ple:
●
To transfer data between a controlling device and the test device, e.g. to run a
remote control program
●
To access or control the measurement from a remote computer using the
"Remote Desktop" application (or a similar tool)
●
To connect external network devices (e.g. printers)
●
To transfer data from a remote computer and back, e.g. using network folders
Connecting to LAN
To Next Page
Loading...
