Instrument Tour
R&S
®
FPL1000
43Getting Started 1179.4657.02 ─ 10
●
In a list, scroll forward and backward through the list entries.
●
In a table, move the selection bar horizontally.
●
In windows or dialog boxes with horizontal scroll bar, move the scroll bar.
5.1.8 RF INPUT 50 Ohm
Provides RF input from a connected device under test (DUT) to the
R&S FPL1000, which is then analyzed in an RF measurement. Connect the DUT
to the "RF Input" on the R&S FPL1000 via a cable equipped with an appropriate
connector. Do not overload the input. For maximum allowed values, see the data
sheet.
See also Chapter 4.14, "Considerations for Test Setup", on page 34.
The specific connector type depends on the instrument model:
●
R&S FPL1003/1007: N female
●
R&S FPL1014: N female
●
R&S FPL1026: Test port adapter, 2.92 mm female (standard) or N female
5.1.9 GEN Output 50 Ω
Provides signal output from the (optional) internal generator (requires Internal
Generator option R&S FPL1-B9). Output levels range from -60 dBm to +10 dBm,
with a resolution of 0.1 dB. For details, see the data sheet.
5.2 Rear Panel View
This figure shows the rear panel view of the R&S FPL1000. The individual ele-
ments are described in more detail in the subsequent sections.
Rear Panel View
To Next Page
Loading...
