Operation in Receiver Mode R&S FSH
1145.5973.12 2.24 E-11
Scanning in the receiver mode:
In the receiver mode, the R&S FSH can scan across a defined number of frequencies and graphically
display the results. It performs a measurement at each frequency for the defined measurement time.
! Press the SPAN softkey.
! Press the FREQ SCAN softkey.
The R&S FSH switches to the scan mode and displays the measurement levels at the individual
frequencies as vertical lines.
! Press the SCAN START softkey.
! Enter the start frequency for the scan.
! Press the SCAN STOP softkey.
! Enter the stop frequency for the scan.
! Press the SCAN STEP softkey.
! Enter the step size for the scan.
It is also possible to scan the frequencies of a channel table. This requires activating a channel table as
follows:
! Press the FREQ softkey.
! Press the CHANNEL MODE softkey.
The R&S FSH now performs a measurement at the frequencies of the channel table.
To Next Page
Loading...
