1GA16_1L.DOC ROHDE & SCHWARZ1
Content
1 INTRODUCTION 3
2 PREPARATIONS 3
2.1 HARDWARE AND SOFTWARE REQUIREMENTS 3
2.2 SOFTWARE INSTALLATION 4
2.3 STARTING THE APPLICATION SOFTWARE 4
2.4 CONFIGURING THE APPLICATION 4
2.4.1 SETUP AND CONFIGURATION FILES 5
2.4.2 PRELIMINARY CONFIGURATION OF SETUP FILE 5
2.5 CONVERTING THE SETUP FOR SOFTWARE UPDATES 6
3 OPERATING CONCEPT 6
3.1 OVERVIEW 7
3.2 SOFTKEY LEVELS 7
3.3 SOFTKEYS COMMON TO ALL LEVELS 7
3.4 ENTRY OF PARAMETERS 7
3.5 COMMON SOFTKEYS FOR POST-PROCESSING 8
4 MEASUREMENT MODES 9
4.1 MODES OF FREQUENCY RESPONSE ANALYSIS 9
4.2 FREQUENCY SWEEP 10
4.2.1 ADVANTAGES 10
4.2.2 SETUP AND PROGRAM SETTINGS 10
4.3 FFT NOISE 10
4.3.1 ADVANTAGES, LIMITS AND MAIN FIELDS OF APPLICATION 11
4.3.2 SETUP AND PROGRAM SETTINGS 11
4.4 SWEPT BURST MEASUREMENT 12
4.4.1 ADVANTAGES AND MAIN FIELDS OF APPLICATION 12
4.4.2 PROGRAM SETTINGS 12
4.5 GO/NOGO TESTS 12
4.6 SELECTING THE MEASUREMENT MODE 13
5 MEASUREMENTS 13
5.1 IMPEDANCE AND ASSOCIATED PARAMETERS 14
5.1.1 TEST SETUP 14
5.1.2 SPECIAL NOTES ON ENTRY OF PARAMETERS 15
5.1.3 DC IMPEDANCE 15
5.1.4 IMPEDANCE FREQUENCY RESPONSE 16
5.1.5 RESONANCE FREQUENCY AND RESONANCE IMPEDANCE 17
5.1.6 ABSOLUTE MINIMUM AND MAXIMUM IMPEDANCE 17
5.1.7 TUNING FREQUENCY 17
To Next Page
Loading...
Need help?
General
