Rohde & Schwarz UPD - Printout at User; Printout During; Restarting Thea

1GA16_1L.DOC ROHDE & SCHWARZ39
7.2.1 Printout at User Interface
The application has to be quit by means of the GOTO UPD softkey (F7), (see section 7.1, Change of
Task Application/User Interface). Same as with normal instrument operation, printout is triggered with the
HCOPY hardkey. Any comment can be entered.
Command:
⇒ PRINT-->Type
is provided in the OPTIONS panel for printing out trace data and limit violations,
• Type TRACE A (for trace data) or
• Type LIM REPORT (for limit violations)
for printout of an ASCII list with corresponding numerical values.
7.2.2 Printout During Running Application
At the end of each measurement softkeys HARDCOPY (F8) and o <--> O (F6) are offered. Thus it is
possible to display or printout measured values with graphics window or full-screen graphics. Comments
cannot be entered but will be printed provided the respective settings have been made in the OPTIONS
panel.
77.3 .3 RestartRestart
7.3.1 Restarting a Measurement
At the end of each measurement a new measurement can be triggered by means of the START softkey
(F12). Modifications made after the end of the first measurement at the user interface (eg special graphics
scaling) are maintained until the program returns to the softkey level for measurement mode (or
measurement) selection (see section 3.2, Softkey Levels).
7.3.2 Restarting the Application
The application can be started again without reloading by means of the RUN softkey (provided the
application is properly concluded) or by entering the BASIC command RUN.