Rohde & Schwarz ZNB - Display:cmap:trace:rgb; Display:cmap<Dispel>:Rgb

Command Reference
R&S
®
ZNB/ZNBT
1044User Manual 1173.9163.02 ─ 54
Parameters:
<Boolean> ON - all markers have the same color, to be defined via
DISPlay:CMAP<DispEl>:RGB <Red>, <Green>, <Blue>.
The marker color is independent of the trace colors.
OFF - each marker has the color of the associated trace.
Example: See DISPlay:CMAP<DispEl>:RGB
Manual operation: See "General > Same Color all Markers" on page 694
DISPlay:CMAP<DispEl>:RGB
<Red>, <Green>, <Blue>[, <TraceStyle>,
<TraceWidth>]
Defines the user color scheme using the Red/Green/Blue color model. For traces also
the line style and width can be defined.
Use DISPlay:CMAP:TRACe:RGB to define the properties of a particular trace, refer-
enced by its name.
Suffix:
<DispEl>
.
Number of the display element as described in the table below.
Parameters:
<Red> Red content of the defined color.
Range: 0 (zero intensity, corresponding to a 0 in the 24-bit
color model) to 1 (full intensity, corresponding to
255 in the 24-bit color model).
<Green> Green content of the defined color.
Range: 0 (zero intensity, corresponding to a 0 in the 24-bit
color model) to 1 (full intensity, corresponding to
255 in the 24-bit color model).
<Blue> Blue content of the defined color.
Range: 0 (zero intensity, corresponding to a 0 in the 24-bit
color model) to 1 (full intensity, corresponding to
255 in the 24-bit color model).
<TraceStyle> SOLid | DASHed | DOTTed | DDOTted | DDDotted
Optional trace style, only for traces (<DispEl> > 12): One of the
string parameters SOLid | DASHed | DOTTed | DDOTted
| DDDotted.
<TraceWidth> Optional trace width, only for traces (<DispEl> > 12).
Range: 1 to 20
SCPI Command Reference