Rohde & Schwarz ZNB - Page 362

GUI Reference
R&S
®
ZNB/ZNBT
362User Manual 1173.9163.02 ─ 54
"Add Marker" adds a new marker.
Related information
Refer to the following sections:
●
Chapter 5.2.1.3, "Markers", on page 96
●
Chapter 4.3.4, "Handling Diagrams, Traces, and Markers", on page 59
Mkr <i> Stimulus / Ref Mkr Stimulus
Gets/sets the stimulus value of the active marker.
Remote command:
CALCulate<Chn>:MARKer<Mk>:X
CALCulate<Chn>:MARKer<Mk>:REFerence:X
Mkr <i> Arb. Response / Ref Mkr Arb. Response
Gets/sets the response value (Y position) of an "Arbitrary" marker (see "Marker Mode"
on page 365).
Remote command:
CALCulate<Chn>:MARKer<Mk>:Y
CALCulate<Chn>:MARKer<Mk>:REFerence:Y
On
Enables/disables the active marker.
Markers remember their "Marker Props" while disabled (see Chapter 6.7.2, "Marker
Props Tab", on page 364). The marker properties are definitely lost when the associ-
ated trace is deleted.
Marker Softtool