Rohde & Schwarz ZNB - Page 5

Contents
R&S
®
ZNB/ZNBT
5User Manual 1173.9163.02 ─ 54
5.3.7 Stability Factors...........................................................................................................133
5.3.8 Delay, Aperture, Electrical Length...............................................................................134
5.4 Operations on Traces............................................................................................... 135
5.4.1 Limit Check................................................................................................................. 135
5.4.2 Trace Files...................................................................................................................142
5.4.3 Memory-Mapped Trace Data Transfer........................................................................ 147
5.5 Calibration................................................................................................................. 149
5.5.1 Calibration Types........................................................................................................ 150
5.5.2 Calibration Standards and Calibration Kits................................................................. 161
5.5.3 Calibration Pool...........................................................................................................168
5.5.4 Calibration Labels....................................................................................................... 168
5.5.5 Automatic Calibration.................................................................................................. 168
5.5.6 Scalar Power Calibration.............................................................................................175
5.5.7 SMARTerCal................................................................................................................181
5.5.8 Parallel Calibration of Multiple Channels.................................................................... 183
5.6 Offset Parameters and De-/Embedding.................................................................. 184
5.6.1 Offset Parameters....................................................................................................... 184
5.6.2 Embedding and Deembedding....................................................................................190
5.7 Optional Extensions and Accessories....................................................................202
5.7.1 Additional Test Ports (R&S ZNBT only).......................................................................203
5.7.2 Time Domain Analysis.................................................................................................203
5.7.3 Distance to Fault Measurements................................................................................ 216
5.7.4 Frequency Conversion Measurements....................................................................... 217
5.7.5 Receiver Bandwidth 10 MHz.......................................................................................227
5.7.6 Frequency Resolution 1 mHz......................................................................................228
5.7.7 Measurement Uncertainty Analysis.............................................................................228
5.7.8 Eazy De-embedding Based on IEEE 370................................................................... 230
5.7.9 In-situ De-Embedding................................................................................................. 232
5.7.10 Smart Fixture De-Embedding......................................................................................232
5.7.11 Delta-L 4.0 PCB Characterization............................................................................... 232
5.7.12 Bias Tees (R&S ZNB only).......................................................................................... 233
5.7.13 Internal Second Source...............................................................................................234
5.7.14 Precision Frequency Reference..................................................................................234