GUI Reference
R&S
®
ZNB/ZNBT
533User Manual 1173.9163.02 ─ 54
The control elements in the "Modify Cal Power" dialog are described in the following
sections:
●
"Channel Base Power" on page 493
●
"Port Power Offset" on page 493
●
"Cal Power Offset" on page 493
Receiver Level Tab
Provides access to the receiver step attenuator settings.
Receiver step attenuators are optional hardware (see Chapter 5.7.22, "Receiver Step
Attenuators", on page 240).
Attenuation
Sets the attenuation at the respective measurement receiver (b-wave). See "Step
Attenuators" on page 386.
Remote command:
[SENSe<Ch>:]POWer:ATTenuation
Channel Config Softtool
To Next Page
Loading...
