Rohde & Schwarz ZNB - Page 575

GUI Reference
R&S
®
ZNB/ZNBT
575User Manual 1173.9163.02 ─ 54
Move Up / Move Down
Allows you to modify the sequence in which the active port set deembeddings/embed-
dings are applied.
Add / Delete
Allows you to define the "Port Sets" to whom a deembedding or embedding network
can be assigned.
The "Add" button opens the "Define Port Set" dialog that allows you to define an addi-
tional port set, comprising two or more physical ports.
Use the controls on the right-hand side of the dialog to define the port set and the order
of the ports within the port set.
Note however that the speed of the de-/embedding calculation depends on the port
order. The best perfomance is achieved if the ports are ordered according to their num-
bers (i.e. in natural order). This is particularly significant for large port sets.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:PPAir:DEEMbedding<ListId>:
DEFine
CALCulate<Ch>:TRANsform:VNETworks:PSET:DEEMbedding<ListId>:
DEFine
CALCulate<Ch>:TRANsform:VNETworks:PPAir:DEEMbedding:DELete
CALCulate<Ch>:TRANsform:VNETworks:PPAir:EMBedding<ListId>:DEFine
CALCulate<Ch>:TRANsform:VNETworks:PSET:EMBedding<ListId>:DEFine
CALCulate<Ch>:TRANsform:VNETworks:PPAir:EMBedding<ListId>:DELete
Active
The checkboxes in the "Active" column activate or deactivate the configured de-/
embeding for the related port set (i.e. adds or removes it to/from the calculation flow)
without changing its parameters.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:PPAir:DEEMbedding<ListId>[:
STATe]
CALCulate<Ch>:TRANsform:VNETworks:PPAir:EMBedding<ListId>[:
STATe]
Offset Embed Softtool