Rohde & Schwarz ZNB - Page 684

GUI Reference
R&S
®
ZNB/ZNBT
684User Manual 1173.9163.02 ─ 54
Export to File... ← Contents
Opens a dialog that allows to export the (filtered) content of the fault list to an ASCII file
with configurable "Field Separator" and "Decimal Separator".
This CSV type file contains one line (terminated by CR+LF) per fault. With ";" as "Field
Separator" and "." as "Decimal Separator", the fault list of Figure 6-73 is exported to
1; Trc1; 457.2 mm; -8.56 dB
2; Trc1; 1.539 m; -9.24 dB
For an explanation of the possible filters, see "Contents" on page 683).
Tracking Enabled
If checked (default), the "Fault Table" on page 683 is cleared at every sweep start and
populated in real time. Uncheck "Tracking Enabled" to freeze the table contents.
6.16 Display Softtool
The "Display" softtool provides all display settings and the functions for activating,
modifying and arranging different diagrams.
Access: SYSTEM – [DISPLAY]
Related information
Refer to the following sections:
●
Chapter 5.1.3, "Traces, Channels and Diagrams", on page 82
●
Chapter 5.2.1, "Display Elements of a Diagram", on page 93
●
Chapter 4.3.4, "Handling Diagrams, Traces, and Markers", on page 59
6.16.1 Diagram Tab
Selects a diagram as the active diagram, defines a title, deletes or adds diagrams and
arranges them on the screen. Many of the functions are unavailable if the active recall
set contains only one diagram.
Display Softtool