Getting Started
R&S
®
ZNB/ZNBT
73User Manual 1173.9163.02 ─ 54
test ports. It is recommended that you preset the R&S ZNB/ZNBT to start from a well-
defined instrument state.
DUT
1 2
VNA
1 2
2
3 4
5 6 7 8
9
10 11 12
13 14 15 16
1
18 19 20
21 22 23 24
17
DUT
1 2
VNA
1. Connect the DUT between test ports 1 and 2 of the network analyzer as shown
above.
2. Switch on the instrument and start the VNA application.
Proceed as described in Chapter 4.1.7, "Starting the Analyzer and Shutting Down",
on page 24.
Performing Measurements
To Next Page
Loading...
