Rohde & Schwarz ZNB20 - Calculate:fmodel:delt<Ph_Pt>:Run; Calculate:fmodel:delt<Ph_Pt>:Sweep:control:ifbw

Command Reference
R&S
®
ZNB/ZNBT
845User Manual 1173.9163.02 ─ 54
CALCulate:FMODel:DELT<Ph_pt>:RUN
Runs the AITT-DL tool with the collected measurement data and the configured Delta-L
settings.
Suffix:
<Ph_pt>
.
This suffix is ignored
Usage: Event
Options: R&S ZNB/ZNBT-K231
Manual operation: See "Run" on page 619
CALCulate:FMODel:DELT<Ph_pt>:SWEep:CONTrol
<SweepControl>
Tells the firmware to use either default values for frequency step size and IF band-
width, or the settings of the active channel for the Delta-L measurement.
The resulting frequency step size and IF bandwidth can be queried using CALCulate:
FMODel:DELT<Ph_pt>:SWEep:CONTrol:STEP? on page 846 and CALCulate:
FMODel:DELT<Ph_pt>:SWEep:CONTrol:IFBW? on page 845, respectively.
Suffix:
<Ph_pt>
.
This suffix is ignored
Parameters:
<SweepControl> DEFault | CURRent
DEFault
Use the default values of the Delta-L algorithm:
10 MHz frequency step size, 1 kHz IF bandwidth
SweepControl
Use the values of the active channel
Options: R&S ZNB/ZNBT-K231
Manual operation: See "Sweep Control" on page 616
CALCulate:FMODel:DELT<Ph_pt>:SWEep:CONTrol:IFBW?
For the Delta-L measurement, the firmware can either use a default IF bandwidth, or
the active channel setting (see CALCulate:FMODel:DELT<Ph_pt>:SWEep:
CONTrol).
This query returns the resulting IF bandwidth.
Suffix:
<Ph_pt>
.
This suffix is ignored
Usage: Query only
Options: R&S ZNB/ZNBT-K231
Manual operation: See "Sweep Control" on page 616
SCPI Command Reference