EasyManua.ls Logo

Rohr DFC-10P - Safety Instructions; Technical Data

Rohr DFC-10P
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DFC-10P / DFC-50P / DFC-450P / DFC-650P
Please read and understand this manual and the manual for the product / battery you are intending to charge
before operating this device. Keep this manual for future reference.
1. Only use this device indoors and for its intended use.
2. No warranty is offered for damages resulting from improper use or incorrect operation of this device.
3. This device is not intended to be used by persons (including children) with limited physical, sensory or mental
aptitude or lack of experience and/or knowledge.
4. In the event of a fault or failure, any repairs to this battery charger must be done by a qualied person authorised
by the manufacturer.
5. Keep the power cable away from sources of heat and check the condition of it regularly. If it’s damaged, have the
cable replaced by a qualied person.
6. Do not use the charger if damaged or defective and do not charge disposable, frozen or damaged batteries.
7. Protect the charger against the elements, especially rainfall. Use the device in well ventilated areas only.
8. Do not leave the charger connected to a power supply when not in use.
9. When charging, batteries emit gasses that may be explosive. Keep away from any heat sources.
10. Make sure the battery charger is disconnected from a power source when connecting to a battery.
11. Never place a battery right under or on top of the battery charger. Place the battery charger as far away from the
battery as possible. Never place the battery charger under the bonnet.
12. Always make sure the car and battery manufacturers permit the use of a battery charger jump start prior to using
this function (applicable models only).
13. Warning, danger to life - when cleaning, never immerse the device in water or other liquids and never open the
product housing.
Safety Instructions
3
MODEL
INPUT
VOLTAGE
(V)
OUTPUT
VOLTAGE
(V)
CHARGING
CURRENT
(A)
MAX
CHARGING
CURRENT
(A)
FUNCTION
STARTING
CURRENT
(A)
CHARGING
INPUT
POWER (W)
STARTING
INPUT
POWER (W)
BATTERY
CAPACITY
DFC-10P 230 6/12 5/8 10 Charge N/A 250 N/A 20-150ah
DFC-50P 230 12/24 20/30 45
Charge/
Start
130 950 6400 50-350ah
DFC-450P 230 12/24 40/50 70
Charge/
Start
300 1200 8500
100-
700ah
DFC-650P 230 12/24 60/70 100
Charge/
Start
480 2200 12000
120-
1000ah
Technical Data

Related product manuals