10.2. When you first fill a basin the water may sometimes appear
milky. This is due to very tiny air bubbles in the water which will
clear very quickly.
10.3. If water is seen dripping through the tundish at any time
switch off the electricity supply immediately and call the installer
or the Rointe customer service department on the number listed
at the end of this manual.
11. SERVICING AND MAINTENANCE
11.1. Servicing and maintenance must only be carried out by
a competent unvented hot water heater installer or by Rointe
authorised personnel.
11.2 . Before any work whatsoever is carried out on the installation,
it MUST first be isolated from the mains electricity supply.
11.3. Only use spare parts authorised by Rointe. The use of other
parts will invalidate the warranty.
11.4. Drain the cylinder – When draining the cylinder, always switch
off the water heater. Turn off the water supply at the stopcock (see
Figure 2). Connect a hosepipe to the drain cock (see Figure 2)
and route it to a convenient gully. Open the drain cock and all hot
taps that are served by the cylinder. The cylinder may take several
minutes to empty completely.
11.5. The magnesium anode must be checked at least once a
year, and must be replaced if worn or defective.
11.6. Remove the cartridge from the pressure reducing valve.
Check the strainer and if necessary remove any debris from in
front of it. Replace the cartridge.
To Next Page
Loading...
