ROL | ERGO Sweden W: www.rolergo.com P: +46 36 36 88 80
10
DANGER
Grounding Instruction:
This product does NOT require grounding to earth.
This product is double insulated and equipped with a non-
polarized 120V plug and 2-conductor cord. The plug must be
plugged into an appropriate building outlet that is properly
installed in accordance with all local codes and ordinances.
DANGER
Risk of electrical shock:
Improper connection of the equipment can result in a risk of electric shock. Check with
a qualified electrician for any concerns. Do not modify the plug provided with the pro-
duct – if it will not fit the outlet have a proper outlet installed by a qualified electrician.
This product is designed for the voltage indicated on the power supply label. No adap-
ters should be used with this product.
CAUTION
Risk of electrical shock:
Before you plug in the power cord, check the following again:
• The voltage must be as specified on the power supply label.
• When the power cord is plugged in, the electrical control devices are operational.
NOTICE
In case of a main power breakdown, or if the power cord is unplugged during the mo-
vement of the drives, a manual reset may be necessary! Please see section 3.2 manual
reset.
2.4 System configuration (example)
The figure below shows the motor driving assignment for a configuration example.
This configuration consists of:
1. Power Supply
2. Motor cables
3. Handset
To Next Page
Loading...
