Product Code:
Product Name:
5
AT
TACH MOUNTING CLAMPS
• Place mounting brackets on top of each
sp
acer block. The square holes in
brackets must engage the squares on
spacer blocks.
• Install u-bolts around cross bars and into
slots in mounting brackets.
• Install plastic knobs onto u-bolts.
• Tighten all plastic knobs firmly and evenly.
• Tighten vehicle’s cross bars.
• Make sure installation is secure by pulling
side-to-side and fore and aft on basket.
NOTE: The cargo carrier should not move
on cross bars when plastic knobs are
tig
htened properly.
WARNING: There must be a minimum of ½”
of threads engaged on u-bolt on all plastic
kn
obs.
CAUTION:
• As with any metal equipment it is recommended that you keep the product clean and remove road salt and debris.
• Do not allow harsh chemicals, road salt, or mud to accumulate on the product for an extended period of time.
• Wash the product with mild soap and water only and a non-abrasive cloth.
Plastic Knob
Mo
unting
Bracket
Spacer Block
cross bar
U-Bolt
Basket
INCORRECT
CORRECT
3-1/4” Max.
1-
1/4” Max.
½” Min.
cross bar
• Longer loads, such as canoes or kayaks,
M
UST be tied down to the front and rear of
vehicle.
Please read all instructions carefully before assembly, installation and/or use of this product.
59505
Roof Top Carrier Extension
To Previous Page
Loading...
