Roland 3000s - Safety and Compliance; Important Safety Instructions; Radio and Television Interference

CAUTOM TO REDUCE TE FISH OF ELECTRIC SHOCK
OO GT REMOVE COVER OR BACH,
MO USER SERVICEAB.E PARTS ОЕ
REFER SERVICING ТО QUALHIED SERVICE PERSONNEL
WARNING When using electric products, basic precau-
tions should always be followed, including
the following;
1. Read all the instructions before using the product.
. To reduce the risk of injury, close supervision is
necessary when a product is used near children.
. Do not use this product near water- for example,
near a bathtub, washbowl, kitchen sink, in a wet
basement, or near a swimming pool, or the like.
. This product should be used only with a cart or
stand that is recommended by the manufacture.
. This product, either alone or in combination with an
amplifier and headphones or speakers, may be
capable of producing sound levels that could cause
permanent hearing loss.
Do not operate for a long period of time at a high
volume level or at level that is uncomfortable. If you
experience any hearing loss or ringíng in the ears,
you should consult an audiologist.
. The product should be located so that its location or
position does not interfere with its proper ventilation.
. The product should be located away from heat
Sources such as radiators, heat registers or other
products that produce heat.
. The product should avoid using in where it may be
effected by dust.
. The product should be connected to a power supply
only of the type described in the operating instruc-
tions or as marked on the product.
The lightning flash with arrowhead symbol, within an equilateral
triangle, is intended to alert the user to the presence of un-
insulated "dangerous voltage" within the product's enclosure
that may be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an eguilateral triangle is intended
to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accom-
panying the product.
IMPORTANT SAFETY INSTRUCTIONS
10. The power-supply cord of the product should be
unplugged from the outlet when left unused for a
long period of time.
. Do not tread on the power-supply cord.
. Do not pull the cord but hold the plug when
unplugging.
. When setting up with any other instruments, the
procedure should be followed in accordance with
instruction manual.
. Care should be taken so that objects do not fall and
liquids are not spilled into the enclosure through
openings.
. The product should be serviced by qualified service
personnel when:
A: The power-supply cord or the plug has been
damaged; or
Objects have fallen, or liquid has been spilled
into the product; or
C: The product has been exposed to rain; or
D: The product does not appear to operate
normaliy or exhibits a marked change in perfor-
mance: or
The product has been dropped, or the enclosure
damaged.
B:
E:
. Do not attempt to service the product beyond that
described in the user-maintenance instructions. All
other servicing should be referred to qualified service
personnel.
SAVE THESE INSTRUCTIONS
The three conductors of the mains
lead attached to this apparatus are
identified with color as shown in the
table below, together with the
matching terminal on the UK type
power plug. When connecting the
mains lead to a plug, be sure to
connect each conductor to the cor-
rect terminal, as indicated.
"This instruction applies to the
product for United Kingdom."
WARNING
THIS APPARATUS MUST BE EARTH GROUNDED.
Conductor |Color | Mark on the matching terminal |
[tive Brown |Red oriettert |
Neutra! | Blue [BackorieterN |
TUE
Green- | Green, Green-Yellow, letter E
Yellow | or symbol
Bescheinigung des Herstellers /Importeurs
Hiermit wird bescheinigt, дай der/die/das
ROLAND ELECTRONIC PIANO. HP- 30005/45008/55005/5600$ _
бешт. Тур Berechnung!
in Übereinstimmung mit den Bestimmungen der
Amtsbl. Vfg 1046 / 1984
lArmtiblattverfugung?
funk-entstórt ist.
Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerates
angezeigt und die Berechtigung zur Überprüfung der Serie auf Einhaltung
der Bestimmungen eingeräumt.
Roland Corporation Osaka / Japan TEA
Name des Heritellers/ importeurs
RADIO AND TELEVISION INTERFERENCE
"Warning - This equipment has been verified to comply with the limits far a Class B computing device,
pursuant to Subpan J. of Part 15. of FCC rules. Operation with non.certified or non-verified equip-
ment i5 likely to result in interference to radio and TV reception."
The equipment described in this manus! generstes and uses radio-frequency energy. H it is nat
installed and used properly, that is, in strict accordance with our instructions, it may cause interfer-
ence with radio and television reception.
This equipment has been tested and found to comply with the limita for a Clasa B computing
device in accordance with the specifications in Subpan J, of Part 15, of FCC Rules. These rules are
designed to provide reasonsble protection against such a interlerance in в residential installation.
However, there is no guarsntee that the interference will not occur in a particular installation. И this
equipment does cause interference to radio or television reception, which can be determined by turning
the equipment on and off, the user is encouraged to try to correct the interference by the
following measure
nnec! other devices and their input-output cables one at а time. Н the interference stops, it
is caused by either the other device or its О cable.
These devices usually require Roland designated shielded I/O cables. For Roland devices, you can
obtain the proper shielded cable from your dealer. For non Roland devices, cantact the manufacturer
or dealer for assistance.
И your equipment does cause interference to radia or television reception. you сап try to corract
the interterence by using ane or more of the following measures
Turn the TV or radio antenna until the interferences stops.
5 Move the equipment to one side or the other of the TV oF radio
* Move the equipment farther away from the TV of radio
* Plug the equipment into an outlet that is an a different circuit than the TV or radio. {That is. make
certain the equipment and (he radio or television set are on circuits controlled by dierent circuit
breakers or fuses.)
* Consider installing a rooftop television antenna with coaxial cable lead-in between the antenna and
Ty.
If necessary. you shouid consult your dealer or an experienced radio television technician for
adavonal suggestions. You may find hetpfui the following booklet prepared by the, Federal Comi-
munications Commision
“How to identify and Resolve Radio-TV Interference Problems”
This bookiet is available trom the US. Government Printing Office. Washington. DC. 20402.
Stock No 004-000-00345-4.