25
Additional Convenient Functionality <Advanced Operation>
If you’ve connected the C-30 to a MIDI sequencer, you should set the C-30 to the Local Off state.
Most sequencers enable their Thru function, so that the notes that you play on the keyboard or that are played back by the
recorder will reach the sound generator section by both routes (1) and (2) if the C-30 is in the Local On state, causing notes to be
sounded in duplicate, or to be cut off unnaturally.
To prevent this, choose the “Local Off” setting so that route (1) is disconnected.
◆
While holding down the [Temperament] button, press the [4’]
button, and while continuing to hold down both buttons,
press the rightmost key (F6) to select Local On or the (B6) key
to select Local Off.
* If you’ve selected Local Off and no sequencer is connected, you won’t
hear any sound when you play the C-30’s keyboard.
The Local On setting is selected when you turn on the power.
V-LINK
V-LINK ( ) is a function that allows music and images to be performed together. By using MIDI to connect two or
more V-LINK compatible devices, you can easily enjoy a wide range of visual effects that are linked to the expressive elements of
a music performance.
1.
While holding down [Temperament], press the [Lute] button.
The [Function] button's indicator will light orange, and V-
LINK will be on. The [Function] button's indicator will
remain lit until you turn V-LINK off.
2.
To turn V-LINK off, once again hold down [Temperament]
and press the [Lute] button.
Local On/Off setting
Using the V-LINK function
MIDI
IN
MIDI
IN
MIDI
OUT
MIDI
OUT
Sequencer
Memory
Sound
Generator
Each note played is
sounded twice
(2) Soft Thru On
(1) Local On
Local On
Sound is emitted
Sound Generator
Local Off
No sound produced
Sound Generator
Local On Local Off
C-30_e.book 25 ページ ２００８年３月１０日 月曜日 午前１０時３１分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
