Roland CM-500 - Rear Panel

@ Rear Panel
MODE SELECTOR KNOB
Switches between sound source setups.
Note: The power must be off in order to change sound source modes (refer to page 9,
the section on Modes).
е” PHONES (Headphone Jack)
Connect headphones here. Signals will still be output from the Audio Outs even though
headphones are connected.
@ OUTPUT (Audio Outs)
The СМ-500% audio signals are output in stereo (L/R). Mono is also possible by using
the L (MONO) jack only.
s MODE
1000m A 3 Е
DC
IN
OY
А
CM-300
+
CHA
32L
R
(МОМО)
УЗ ROLAND АСВ АСК в EMSA SIMUL ATION a
ADAPTOR ONLY C CM-300 PHONES OUTPUT
D CH-500 CM-500
Ф MIDI IN/OUT /THRU (MIDI Connectors)
MIDI data is exchanged with other MIDI devices through these ports. For more infor-
mation about MIDI, see the explanation on page 22.
@ DC IN (AC Adaptor Jack)
Connect the AC adaptor to this inlet.