Roland Compurhythm CR-78

SPECIFICATIONS
• RHYTHM SELECTION BUTTONS
ROCK 1-4, DISCO 1-2, WALTZ, SHUFFLE, SLOW
ROCK,SWING,FOX TROT,TANGO, BOOGIE,ENKA
(a general in Japanese music), BOSSANOVA, SAM¬
BA, MAMBO, CHACHA, BEGUINE, RHUMBA
SOUND SOURCE
BASS DRUM,SNARE DRUM,RIM SHOT, HI-HAT,
CYMBAL, MARACAS, CLAVES,COW BELL, HIGH
BONGO, LOW BONGO, LOW CONGA
VARIATION SELECTOR
FILL IN 1-7, BREAK, RHYTHM (A-B), ROLLING-
HB, SD
MEASURE SELECTOR (2, 4, 8, 12, 16) :1
CONTROL KNOB :4
LEVEL, BALANCE, ACCENT, TEMPO
SWITCH (BUTTON) 7
FADE IN, FADE OUT,
START/STOP, RHYTHM PATTERN SELECTOR,
AUTO/MANUAL SELECTOR, MANUAL POWER
CANCEL BUTTONS :4
CYMBAL + HIGH HAT, BASS DRUM,
SNARE DRUM, COW BELL + CLAVES
ADD VOICE
CONTROL SLIDERS ;2
TAMBOURINE LEVEL, GUIRO LEVEL
CY HH METALLIC BEAT
CONTROL SLIDER :1
METALLIC BEAT LEVEL
INDICATOR :1
TEMPO (also used as Power Source Pilot Lamp)
PROGRAMMER
INSTRUMENTS SELECTOR KNOB :1
Bass Drum, Snare Drum, Rim Shot, High
Hat, Cymbal, Maracas, Claves, High
Bongo, Low Bongo, Low Conga, Accent
SWITCHES (BUTTONS) :2
MEMORY W/D, PLAY, ALL
CLEAR
INDICATORS :4
TRACK 1-4
PROGRAM RHYTHM :4
SELECTION BUTTONS
I, II, III, IV
• JACK
OUTPUT :2
HI: 220 kQ 3.5Vp-p (220kO Load)
Low: lOkO 5.5Vp-p (10kO Load)
(Vol.: max., Acc. Vol.: max.)
FOOT SWITCH .3
START/STOP,VARIATION (DP-1, DP-2)
WRITE (TS-1)
TRIGGER PULSE OUT :1
OFF: OV/ ON:+15V pulse
• TRIGGER PULSE SELECT IN SWITCH :1
8 beat, 16 beat, combination
• EXT. CLOCK :1
OFF:OV/ ON: + 5 —I-15V pulse, min. 5ms width
• POWER CONSUMPTION
13W
• DIMENSIONS
300(W) X 280(D) X 205(H)mm
11,8"(W) X 11,0”(D) x 8.1 "(H)
• NET WEIGHT
5.5 kg
12.1 lbs.
• ACCESSORIES
2.5m connection cord, TS-1
SPECIFICATIONS ARE SUBJECT TO CHANGE
WITHOUT NOTICE.
PRECAUTIONS
* Keep away from interferences that induce high
levels- of noise, such as flourescent lamps, neon
lights and transformers as much as possible.
* Tone quality might vary depending on the amplifier
used.
* Rough manipulation of the power switch can be
the cause of failure in the computer component.
* Avoid places that are dusty, of high temperature or
high humidity.
* Use neutral detergent when cleaning the control'
panel and a soft, dry cloth for the wooden body.
‘Do not use solvents such as paint thinner.
OPTION
PEDAL SWITCH DP-2
CR-78 OWNER'S MANUAL '80 NOV. A-3
Mi Roland