Roland D-50 - Page 16

PLAY MODE
%* The volume balance you have set here is not automatically written into
memory, and therefore will be erased when another Patch is selected.
*To write the Patch with a new Partial Balance setting, follow the
“Writing Procedure” on page 28.
(Pedal Control] By connecting a pedal to the Control Input Jack, you can control
various functions with the pedal.
Pedal Switch
(OP-2,DP-6)
[Pedal Switch]
The connected pedal switch can contro! the function
(parameter}which is selected in the Control Functions.
[Expression Pedal]
This controls the volume of sound.
* Patch Shift function is selected by the manufacturer.
The Patch Shift function allows you to change the
Patch Numbers sequentially. (EV-5)
{e. g.}
[External Contro!]
A function selected in the Control Functions can be!
controlled.
* Tone Volume Balance is selected by the manufacturer.
Pedal Switch
{DP-2,DP-6}
[Pedal Hold Sustain}
Turns on or off the Hold effect, which allows the sound
to be held even after the key is released.
16