Roland D-50 - Env

OUTLINE OF TONE PARAMETERS
d. ENV (Envelope Generator)
This generators a control signal (envelope curve) which controls the
pitch, timbre and volume of each Partial (sound generator).
@P-ENV
This is the ENV which controls pitch. It can be set for two
selected Partial at once.
@TVF ENV
This ENV controls the cutoff point, and can be set for each Partial
separately.
@TVA ENV :
This ENV controls the volume level, This can be set for each
Partial separately.
e. LFO (Low Frequency Oscillator)
This oscillator generates low frequencies only.
Any of the three LFO’s can be used for the two Partials, Vibrato,
PWM growl or tremolo effects can be obtained using these LFO’s.
*A different LFO can be used for each section or a PARTIAL.
@LFO-1
This can control @Pitch, @Pulse Width, @Cutoff Frequency
or @Level.
Q@LFO-2
This can control @Pulse Width, @Cutoff Frequency or ®Level.
@LFO-~3
This can contro! @Pulse Width, @cCutoff Frequency or @Level.