Roland D-50 - Parameters; Pitch

TONE PARAMETERS
2. PARTIAL PARAMETERS
(Restriction of the available parameters caused by Structure]
Depending on what Structure is used, the available parameters may
be different. So, first check the Structure number shown in the
Partial Display, then set the parameters.
Structure Number
Part-1 WG Pitch
CorsC#S FinetSo KF i
(1) In some Structures, some parameters included in a Partial that
uses a PCM sound generator are invalid, The following mark
is shown when the parameters apply even for PCM sounds,
(2) In some Structures which use Ring Modulation, some parameters
in Partial 2 will automatically become the same as for Partial
1, Therefore, the values shown in the Display are irrelevant with
the actual values. The following mark is shown for such
parameters,
a, WG Pitch
(Display 26]
I-41 U2 Stra. 1111
Dorst#S Finet+sa KF sl
Pitch coarse Pitch Fine Key Follow (Pitch)
@Pitch Coarse
This sets the standard pitch of a Partial in semi—tone steps from
Cl to C7.
*The standard pitch is the pitch at C4 (middle C) key.
@Pitch Fine FU
The standard pitch can be altered over about +50cents from —50
to +50.
30