Roland D-50 - Time; This Sets the Time Needed; From Point 1 to Point; From Point 2 to Point

TONE PARAMETERS
@Level 2 RO
This sets the level of point 2 from 0 to 100.
@Time 3
This sets the time needed to reach point 3 from point 2. 0 to
100 are valid.
@level 3 MUG
This seis the level of point 3 from 0 to 100.
@Time 4
This sets the time needed to reach point 4 from point 3, 0 to
100 are valid.
@ Sustain Level RIUM Y53
This sets the level of point 4 from 0 to 100.
@Time 5
This sets the time needed to reach point 5 from the moment the
key is released, 0 to 100 are valid.
@End Level
To lower the level after releasing the key, set this to 0, and to
raise the level, set it to 100.
*The
End
Level
is
retained
until
you
release
and
play
the
key
again.
*1f
the
Levels
of
two
adjacent
points
are
set
to
similar
values,
the
time
between these two points may prove to be shorter than what is
actually set, or even zero.
g. TVF Modulation
(Display 34]
I-i1 Us Streit i141 Part-1 TUF Mod
LFO -3 LFOPisG Aftr-gr
a
|
CJ)
C4
LEO Select LFO Depth Aftertouch Range
@1FO Select FRRIZ)
This
selects
the
LFO
that
changes
the
cutoff
point
periodically
(creating
grow!
effects).
42