Roland D-50 - Ten Key Pad

b. Ten Key Pad
feg.]
EDITING
The Ten Key Pad is mainly used for editing the names of Patches
or Tones, but also can set the values of some parameters (factors).
The parameters which can be edited with the Ten Key Pad are
shown in "Tone Parameters” on page 22.
Changing the volume balance of two Tones from 50 to 25,
Step 1
Step 2
Step 3
Step1 : Step3
Using the Selector Button, select "Volume Balance’.
With the Ten Key Pad, select 25.
Hit the Enter Key.
*If you fail to push the Enter Key, the value you have set will be
erased,
%*If you choose an incorrect value, the Display will respond as
shown below for a few seconds.
Ineut Gata Error
el
13